Tritium concentration measurements in the Joint European Torus divertor by optical spectroscopy of a Penning discharge

Tutkimustuotos: Lehtiartikkelivertaisarvioitu

Tutkijat

  • D. L. Hillis
  • P. D. Morgan
  • J. K. Ehrenberg
  • M. Groth
  • M. F. Stamp
  • M. Von Hellermann
  • V. Kumar

Organisaatiot

  • Oak Ridge National Laboratory
  • Institute for Plasma Research
  • JET Joint Undertaking

Kuvaus

Obtaining precision measurements of the relative concentrations of hydrogen, deuterium, tritium, and helium in the divertor of a tokamak is an important task for nuclear fusion research. Control of the deuterium-tritium isotopic ratio while limiting the helium ash content in a fusion plasma are key factors for optimizing the fuel burn in a fusion reactor, like the International Tokamak Experimental Reactor. A diagnostic technique has been developed to measure the deuterium-tritium isotopic ratio in the divertor of the Joint European Torus with a species-selective Penning vacuum gauge. The Penning discharge provides a source of electrons to excite the neutral hydrogen isotopes in the pumping duct. Subsequently, the visible light from the hydrogen isotopes is collected in an optical fiber bundle, transferred away from the tokamak into a low radiation background area, and analyzed in a high resolution Czerny-Turner spectrometer, which is equipped with a fast charge coupled device camera for optical detection. The intensity of the observed line emission (D α-6561.03 Å and T α- 6560.44 Å) is directly proportional to the partial pressure of each gas found in the divertor. The line intensity of each isotope is calibrated as a function of pressure. The ratio of the line intensities thus provides a direct measurement of the deuterium-tritium isotopic ratio. The lower limit for the determination of the deuterium-tritium isotopic ratio is about 0.5%. The applicable pressure range for this system is from 10 -5 to a few times 10 -3 mbar.

Yksityiskohdat

AlkuperäiskieliEnglanti
Sivut359-362
Sivumäärä4
JulkaisuReview of Scientific Instruments
Vuosikerta70
Numero1 II
TilaJulkaistu - tammikuuta 1999
OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

ID: 3815465