Round Robin study on structural hot-spot and effective notch stress analysis

W. Fricke; A. Bollero; I. Chirica; Y. Garbatov; F. Jancart; A. Kahl; H. Remes; C. M. Rizzo; H. von Selle; A. Urban; L. Wei

Round Robin study on structural hot-spot and effective notch stress analysis

W. Fricke^*
, A. Bollero
, I. Chirica
, Y. Garbatov
, F. Jancart
, A. Kahl
, H. Remes
, C. M. Rizzo
, H. von Selle
, A. Urban
, L. Wei

^*Tämän työn vastaava kirjoittaja

TUHH

Tutkimustuotos: Artikkeli kirjassa/konferenssijulkaisussa › Conference article in proceedings › Scientific › vertaisarvioitu

2 Viittaukset (Web of Science)

Abstrakti

Within the Network of Excellence MARSTRUCT a round robin was carried out where three different structural details were assessed by calculating structural hot-spot stresses or, if applicable, effective notch stresses. The first structural detail deals with the stress increase at thickness steps in plate structures. For two different cases the structural hot-spot stress is determined with different types of models. The second structural detail is the penetration of a longitudinal through a bulkhead with four different hot-spots. The third structural detail deals with the assessment of root failure of single-sided fillet welds. The welded joint of the end connection of a rectangular hollow section member is taken as example. The relevant stress is here the effective notch stress in the fictitiously rounded notch root. In the paper the different modelling techniques applied are described. The results are compared with each other and sources of scatter are identified. Finally recommendations regarding appropriate modelling are derived from the results.

Alkuperäiskieli	Englanti
Otsikko	ADVANCEMENTS IN MARINE STRUCTURES
Toimittajat	CG Soares, PK Das
Kustantaja	Taylor & Francis
Sivut	159-167
Sivumäärä	9
ISBN (painettu)	978-0-415-43725-7
Tila	Julkaistu - 2007
OKM-julkaisutyyppi	A4 Artikkeli konferenssijulkaisussa
Tapahtuma	International Conference on Marine Structures - Glasgow, Iso-Britannia Kesto: 12 maalisk. 2007 → 14 maalisk. 2007 Konferenssinumero: 1

Julkaisusarja

Nimi	Proceedings and Monographs in Engineering Water and Earth Sciences
Kustantaja	TAYLOR & FRANCIS LTD

Conference

Conference	International Conference on Marine Structures
Lyhennettä	MARSTRUCT
Maa/Alue	Iso-Britannia
Kaupunki	Glasgow
Ajanjakso	12/03/2007 → 14/03/2007

Siteeraa tätä

Fricke, W., Bollero, A., Chirica, I., Garbatov, Y., Jancart, F., Kahl, A., Remes, H., Rizzo, C. M., von Selle, H., Urban, A., & Wei, L. (2007). Round Robin study on structural hot-spot and effective notch stress analysis. teoksessa CG. Soares, & PK. Das (Toimittajat), ADVANCEMENTS IN MARINE STRUCTURES (Sivut 159-167). (Proceedings and Monographs in Engineering Water and Earth Sciences). Taylor & Francis.

@inproceedings{adba3301ddb0450dac49aaf19ce2e52c,

title = "Round Robin study on structural hot-spot and effective notch stress analysis",

abstract = "Within the Network of Excellence MARSTRUCT a round robin was carried out where three different structural details were assessed by calculating structural hot-spot stresses or, if applicable, effective notch stresses. The first structural detail deals with the stress increase at thickness steps in plate structures. For two different cases the structural hot-spot stress is determined with different types of models. The second structural detail is the penetration of a longitudinal through a bulkhead with four different hot-spots. The third structural detail deals with the assessment of root failure of single-sided fillet welds. The welded joint of the end connection of a rectangular hollow section member is taken as example. The relevant stress is here the effective notch stress in the fictitiously rounded notch root. In the paper the different modelling techniques applied are described. The results are compared with each other and sources of scatter are identified. Finally recommendations regarding appropriate modelling are derived from the results.",

author = "W. Fricke and A. Bollero and I. Chirica and Y. Garbatov and F. Jancart and A. Kahl and H. Remes and Rizzo, \{C. M.\} and \{von Selle\}, H. and A. Urban and L. Wei",

year = "2007",

language = "English",

isbn = "978-0-415-43725-7",

series = "Proceedings and Monographs in Engineering Water and Earth Sciences",

publisher = "Taylor \& Francis",

pages = "159--167",

editor = "CG Soares and PK Das",

booktitle = "ADVANCEMENTS IN MARINE STRUCTURES",

address = "United States",

note = "International Conference on Marine Structures, MARSTRUCT ; Conference date: 12-03-2007 Through 14-03-2007",

}

Fricke, W, Bollero, A, Chirica, I, Garbatov, Y, Jancart, F, Kahl, A, Remes, H, Rizzo, CM, von Selle, H, Urban, A & Wei, L 2007, Round Robin study on structural hot-spot and effective notch stress analysis. julkaisussa CG Soares & PK Das (toim), ADVANCEMENTS IN MARINE STRUCTURES. Proceedings and Monographs in Engineering Water and Earth Sciences, Taylor & Francis, Sivut 159-167, International Conference on Marine Structures, Glasgow, Iso-Britannia, 12/03/2007.

Round Robin study on structural hot-spot and effective notch stress analysis. / Fricke, W.; Bollero, A.; Chirica, I. et al.
ADVANCEMENTS IN MARINE STRUCTURES. toim. / CG Soares; PK Das. Taylor & Francis, 2007. s. 159-167 (Proceedings and Monographs in Engineering Water and Earth Sciences).

Tutkimustuotos: Artikkeli kirjassa/konferenssijulkaisussa › Conference article in proceedings › Scientific › vertaisarvioitu

TY - GEN

T1 - Round Robin study on structural hot-spot and effective notch stress analysis

AU - Fricke, W.

AU - Bollero, A.

AU - Chirica, I.

AU - Garbatov, Y.

AU - Jancart, F.

AU - Kahl, A.

AU - Remes, H.

AU - Rizzo, C. M.

AU - von Selle, H.

AU - Urban, A.

AU - Wei, L.

N1 - Conference code: 1

PY - 2007

Y1 - 2007

N2 - Within the Network of Excellence MARSTRUCT a round robin was carried out where three different structural details were assessed by calculating structural hot-spot stresses or, if applicable, effective notch stresses. The first structural detail deals with the stress increase at thickness steps in plate structures. For two different cases the structural hot-spot stress is determined with different types of models. The second structural detail is the penetration of a longitudinal through a bulkhead with four different hot-spots. The third structural detail deals with the assessment of root failure of single-sided fillet welds. The welded joint of the end connection of a rectangular hollow section member is taken as example. The relevant stress is here the effective notch stress in the fictitiously rounded notch root. In the paper the different modelling techniques applied are described. The results are compared with each other and sources of scatter are identified. Finally recommendations regarding appropriate modelling are derived from the results.

AB - Within the Network of Excellence MARSTRUCT a round robin was carried out where three different structural details were assessed by calculating structural hot-spot stresses or, if applicable, effective notch stresses. The first structural detail deals with the stress increase at thickness steps in plate structures. For two different cases the structural hot-spot stress is determined with different types of models. The second structural detail is the penetration of a longitudinal through a bulkhead with four different hot-spots. The third structural detail deals with the assessment of root failure of single-sided fillet welds. The welded joint of the end connection of a rectangular hollow section member is taken as example. The relevant stress is here the effective notch stress in the fictitiously rounded notch root. In the paper the different modelling techniques applied are described. The results are compared with each other and sources of scatter are identified. Finally recommendations regarding appropriate modelling are derived from the results.

M3 - Conference article in proceedings

SN - 978-0-415-43725-7

T3 - Proceedings and Monographs in Engineering Water and Earth Sciences

SP - 159

EP - 167

BT - ADVANCEMENTS IN MARINE STRUCTURES

A2 - Soares, CG

A2 - Das, PK

PB - Taylor & Francis

T2 - International Conference on Marine Structures

Y2 - 12 March 2007 through 14 March 2007

ER -

Round Robin study on structural hot-spot and effective notch stress analysis

Abstrakti

Julkaisusarja

Conference

Sormenjälki

Siteeraa tätä