Passivation of Detector‐Grade FZ‐Si with ALD‐Grown Aluminium Oxide

Tutkimustuotos: Lehtiartikkeli

Tutkijat

Organisaatiot

  • Helsinki Institute of Physics

Kuvaus

Silicon radiation and particle detectors are traditionally passivated with thermal silicon dioxide. It has been shown that aluminium oxide (Al2O3) films provide better surface passivation due to their high negative charge, but studies on Al2O3 surface passivation are usually performed on low‐resistivity substrates. In this article, the passivation of high‐resistivity, detector‐grade float‐zone silicon with Al2O3 is studied, with a specific emphasis on the effect of post‐anneal temperature on carrier lifetimes and film properties. It is confirmed that Al2O3 provides excellent surface passivation also on high‐resistivity FZ‐Si substrates, with a low interface defect density of around (2–4) × 1011 cm−2eV−1 and high negative oxide charge of 1 × 1012 to 3 × 1012 q cm−2, when post‐annealed at temperatures of up to 450–500 °C. In addition, high‐resistivity samples are studied for the phenomenon of bulk lifetime degradation occurring at typical post‐anneal or metal sintering temperatures, which has been reported for low‐resistivity FZ silicon. At post‐anneal temperatures of >500 °C, reduced bulk lifetimes are observed if the substrates did not receive high‐temperature treatment prior to surface passivation. Furthermore, it is noticed that n‐type samples exhibit lower bulk lifetimes even when a high‐temperature treatment was performed, which indicates a connection between FZ‐Si bulk lifetime degradation and doping type.

Yksityiskohdat

AlkuperäiskieliEnglanti
JulkaisuPhysica Status Solidi (A) Applications and Materials Science
TilaSähköinen julkaisu (e-pub) ennen painettua julkistusta - 11 heinäkuuta 2019
OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

ID: 35318497