Optimization of the CCT Curves for Steels Containing Al, Cu and B

Jyrki Miettinen, Sami Koskenniska*, Mahesh Somani, Seppo Louhenkilpi, Aarne Pohjonen, Jari Larkiola, Jukka Kömi

*Tämän työn vastaava kirjoittaja

Tutkimustuotos: LehtiartikkeliArticleScientificvertaisarvioitu

8 Lataukset (Pure)

Abstrakti

New continuous cooling transformation (CCT) equations have been optimized to calculate the start temperatures and critical cooling rates of phase formations during austenite decomposition in low-alloyed steels. Experimental CCT data from the literature were used for applying the recently developed method of calculating the grain boundary soluble compositions of the steels for optimization. These compositions, which are influenced by solute microsegregation and precipitation depending on the heating/cooling/holding process, are expected to control the start of the austenite decomposition, if initiated at the grain boundaries. The current optimization was carried out rigorously for an extended set of steels than used previously, besides including three new solute elements, Al, Cu and B, in the CCT-equations. The validity of the equations was, therefore, boosted not only due to the inclusion of new elements, but also due to the addition of more low-alloyed steels in the optimization. The final optimization was made with a mini-tab tool, which discarded statistically insignificant parameters from the equations and made them prudently safer to use. Using a thermodynamic-kinetic software, IDS, the new equations were further validated using new experimental CCT data measured in this study. The agreement is good both for the phase transformation start temperatures as well as the final phase fractions. In addition, IDS simulations were carried out to construct the CCT diagrams and the final phase fraction diagrams for 17 steels and two cast irons, in order to outline the influence of solute elements on the calculations and their relationship with literature recommendations.

AlkuperäiskieliEnglanti
Sivut1640–1663
Sivumäärä24
JulkaisuMetallurgical and Materials Transactions B: Process Metallurgy and Materials Processing Science
Vuosikerta52
Numero3
Varhainen verkossa julkaisun päivämäärä30 maaliskuuta 2021
DOI - pysyväislinkit
TilaJulkaistu - kesäkuuta 2021
OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

Sormenjälki

Sukella tutkimusaiheisiin 'Optimization of the CCT Curves for Steels Containing Al, Cu and B'. Ne muodostavat yhdessä ainutlaatuisen sormenjäljen.

Siteeraa tätä