Mechanical response of filament wound composite rings under tension and compression

Frederico Eggers, José Humberto S. Almeida*, Cristiano B. Azevedo, Sandro C. Amico

*Tämän työn vastaava kirjoittaja

Tutkimustuotos: LehtiartikkeliArticleScientificvertaisarvioitu

20 Sitaatiot (Scopus)

Abstrakti

This study aims at evaluating the influence of the winding angle, stacking sequence and diameter-to-thickness ratio on the mechanical response of composite rings subjected to radial compression, axial compression and hoop tensile loadings. The rings were obtained from filament wound tubes. The rings were found highly dependent on the winding angle, i.e. the specimens with fibers at ±90° presented the best radial compressive characteristics, whereas those wound at ±60° performed best under axial compression, and apparent hoop tensile strength determined via split disk testing was higher for rings wound at ±90°. All rings were dependent on the diameter-to-thickness ratio. Failure was studied through micrographs of post-mortem specimens. The dominant failure modes for radial compression, axial compression and hoop tensile loadings were, respectively, delamination, delamination and minor off-axis cracks, and fiber/matrix debonding and fiber breakage.

AlkuperäiskieliEnglanti
Artikkeli105951
JulkaisuPolymer Testing
Vuosikerta78
DOI - pysyväislinkit
TilaJulkaistu - 1 syyskuuta 2019
OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

Sormenjälki

Sukella tutkimusaiheisiin 'Mechanical response of filament wound composite rings under tension and compression'. Ne muodostavat yhdessä ainutlaatuisen sormenjäljen.

Siteeraa tätä