Lightweight Design with Welded High-Frequency Mechanical Impact (HFMI) Treated High-Strength Steel Joints from S700 under Constant and Variable Amplitude Loadings
Tutkimustuotos: Lehtiartikkeli › › vertaisarvioitu
- Fraunhofer Institute for Structural Durability and System Reliability LBF
- Chalmers University of Technology
microstructure and local stress concentrators, as well as tensile residual stresses which occur due to the welding process. Investigations carried out under fully-reversed, constant amplitude loading with longitudinal stiffeners of the steel grade S700 show impressive fatigue strength improvement far superior
to those observed using other mechanical treatments such as hammering or shot peening. Considerable potential for lightweight design is observed when implementing HFMI; especially in cases which can be characterised by constant amplitude loading. Under fully-reversed, variable amplitude loading with a
straight-line spectrum, the fatigue strength could be improved by HFMI. However, the degree of improvement was lower when compared to constant amplitude loading due to local plasticity which occurs during larger load levels and consequently reduces the beneficial compressive residual stresses. Apart from the HFMI-treatment, the exceedance of constant amplitude loading (Woehler-lines) by variable amplitude loading (Gassner-lines) offers further lightweight potential, despite the lower degree of improvement by HFMI under spectrum loading. During design, other failure modes and restrictions must be
respected if lightweight designs by HFMI-treatment are to be realised. Professional execution of the treatment and good quality control, as well as accessibility of all fatigue-critical areas to the treatment is needed. Regarding cumulative damage calculations IIW recommendations can be applied atisfyingly.
The current state of knowledge suggests that more data is required about the influence of weld geometry, spectrum shape, loading mode and residual stress state are needed before general rules for HFMI treated welded joints subject to variable amplitude loading can be made. This is due to the fact that the interaction of these parameters determines the degree of improvement with respect to the aswelded state.
|Julkaisu||INTERNATIONAL JOURNAL OF FATIGUE|
|Tila||Julkaistu - lokakuuta 2016|
|OKM-julkaisutyyppi||A1 Julkaistu artikkeli, soviteltu|