The optimal combined use of composites and metallic material is essential for the performance of modern tactical aircrafts. At the same time, the resulting structures include complex metal-to-composite joints that may develop failures during use. The inspection of such structures is often highly demanding. The present paper discusses the complex inspection of stepped-lap joint between carbon fibre wing panel and titanium attachment of tactical aircraft. The joint has been found to be susceptible to disbonding both in the outer and inner titanium to carbon fibre interfaces. Due to the multi-material multi-layer structure, the inspection is particularly demanding, especially for the inner interface. Successful inspection can be developed by careful analysis of the ultrasonic signal. A flawless joint on the outer interface will result in phase change at the interface, that can be seen on the RF signal. A disbond prohibits this phase change and thus can be detected by noting the absense of this phase change. Defects bigger than 4 mm can be detected using this effect. Disbond on the outer surface will prohibit sound from traveling to the inner surface. Consequently, disbond on outer surface can be detected by noting a decreased amplitude in the inner-interface echo. A disbond on the inner surface will, likewise, prohibit sound from going through the interface and thus increase reflection from that interface. Consequently, a disbond on the inner surface can be detected by noting an increase in the amplitude of the inner-interface echo. Thus disbonds on both inner and outer surfaces can be detected by monitoring possible decrease or increase in the inner surface echo indicating disbond in the outer or inner surface, respectively.
|Tila||Julkaistu - 1 elokuuta 2018|
|OKM-julkaisutyyppi||B3 Ei-soviteltu artikkeli konferenssin julkaisusarjassa|
|Tapahtuma||European Conference on Non-Destructive Testing - Gothenburg, Ruotsi|
Kesto: 11 kesäkuuta 2018 → 15 kesäkuuta 2018
|Nimi||The e-Journal of Nondestructive Testing|
|Conference||European Conference on Non-Destructive Testing |
|Ajanjakso||11/06/2018 → 15/06/2018|