In-Plane Compression and Biopolymer Permeation Enable Super-stretchable Fiber Webs for Thermoforming toward 3-D Structures

Tutkimustuotos: Lehtiartikkeli

Tutkijat

Organisaatiot

  • North Carolina State University
  • VTT Technical Research Centre of Finland
  • Auburn University

Kuvaus

The typically poor ductility of cellulosic fibers and ensuing bonded networks and paper webs set limits on any effort to produce associated three-dimensional structures without relying on chemical, often unsustainable, approaches. To address this challenge, we report on a facile and green method that combines mechanical and biopolymer treatment: in-plane compression and aqueous solution permeation via spraying. The first enabled network extensibility while the second, which relied on the use of either food-grade gelatin, guar gum, or polylactic acid, improved network strength and stiffness. As a result, an unprecedented elongation of ∼30% was achieved after unrestrained drying of the fiber web. At the same time, the structures experienced a significant increase in tensile strength and stiffness (by ∼306% and ∼690%, respectively). Such simultaneous property improvement, otherwise very difficult to achieve, represents a substantial gain in the material's toughness, which results from the synergistic effects associated with the mechanical response of the network under load, fiber intrinsic strength, and interfiber bonding. The level of plasticity developed in fiber webs upon biaxial compaction (longitudinal followed by lateral compaction), which was performed to reduce property anisotropy, allowed the synthesis of 3-D packaging materials via direct thermoforming. Moreover, the formability was found to be temperature and humidity dependent (strain and creep compliance after creep/recovery cycles in dynamic mechanical analyses). Overall, an inexpensive, green, and scalable approach is introduced to expand the properties spaces for paper and related non-wovens that allows 2-D and 3-D formability of in-plane compacted fiber networks.

Yksityiskohdat

AlkuperäiskieliEnglanti
Sivut9114-9125
Sivumäärä12
JulkaisuACS Sustainable Chemistry and Engineering
Vuosikerta5
Numero10
TilaJulkaistu - 2 lokakuuta 2017
OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

ID: 15872256