Heavy Alkali Treatment of Cu(In,Ga)Se2 Solar Cells: Surface versus Bulk Effects

Tutkimustuotos: Lehtiartikkelivertaisarvioitu

Tutkijat

  • Susanne Siebentritt
  • Enrico Avancini
  • Marcus Bär
  • Jakob Bombsch
  • Emilie Bourgeois
  • Stephan Buecheler
  • Romain Carron
  • Celia Castro
  • Sebastien Duguay
  • Roberto Félix
  • Evelyn Handick
  • Dimitrios Hariskos
  • Philip Jackson
  • Thomas Kunze
  • Maria Malitckaya
  • Roberto Menozzi
  • Milos Nesladek
  • Nicoleta Nicoara
  • Martti Puska
  • Mohit Raghuwanshi
  • Philippe Pareige
  • Sascha Sadewasser
  • Giovanna Sozzi
  • Ayodhya Nath Tiwari
  • Shigenori Ueda
  • Arantxa Vilalta-Clemente
  • Thomas Paul Weiss
  • Florian Werner
  • Regan G. Wilks
  • Wolfram Witte
  • Max Hilaire Wolter

Organisaatiot

  • University of Luxembourg
  • Swiss Federal Laboratories for Materials Science and Technology (Empa)
  • Helmholtz Centre Berlin for Materials and Energy
  • Helmholtz-Institute Erlangen-Nürnberg for Renewable Energy (HI ERN)
  • Friedrich-Alexander University Erlangen-Nürnberg
  • Hasselt University
  • Institut national des sciences appliquées de Rouen Normandie
  • Zentrum für Sonnenenergie- und Wasserstoff-Forschung Baden-Württemberg
  • University of Parma
  • International Iberian Nanotechnology Laboratory
  • National Institute for Materials Science Tsukuba
  • Université de Poitiers

Kuvaus

Chalcopyrite solar cells achieve efficiencies above 23%. The latest improvements are due to post-deposition treatments (PDT) with heavy alkalis. This study provides a comprehensive description of the effect of PDT on the chemical and electronic structure of surface and bulk of Cu(In,Ga)Se2. Chemical changes at the surface appear similar, independent of absorber or alkali. However, the effect on the surface electronic structure differs with absorber or type of treatment, although the improvement of the solar cell efficiency is the same. Thus, changes at the surface cannot be the only effect of the PDT treatment. The main effect of PDT with heavy alkalis concerns bulk recombination. The reduction in bulk recombination goes along with a reduced density of electronic tail states. Improvements in open-circuit voltage appear together with reduced band bending at grain boundaries. Heavy alkalis accumulate at grain boundaries and are not detected in the grains. This behavior is understood by the energetics of the formation of single-phase Cu-alkali compounds. Thus, the efficiency improvement with heavy alkali PDT can be attributed to reduced band bending at grain boundaries, which reduces tail states and nonradiative recombination and is caused by accumulation of heavy alkalis at grain boundaries.

Yksityiskohdat

AlkuperäiskieliEnglanti
Artikkeli1903752
Sivut1-15
Sivumäärä15
JulkaisuAdvanced Energy Materials
TilaSähköinen julkaisu (e-pub) ennen painettua julkistusta - 1 tammikuuta 2020
OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

ID: 41006501