Elastoplastic Modelling of an In Situ Concrete Spalling Experiment using the Ottosen Failure Criterion

Tutkimustuotos: LehtiartikkeliArticleScientificvertaisarvioitu

4 Sitaatiot (Scopus)
447 Lataukset (Pure)

Abstrakti

An in situ concrete spalling experiment will be carried out in the ONKALO rock characterization facility. The purpose is to establish the failure strength of a thin concrete liner on prestressed rock surface, when the stress states in both rock and concrete are increased by heating. A cylindrical hole 1.5 m in diameter and 7.2 m in depth is reinforced with a 40 mm thin concrete liner from level -3 m down. Eight 6 m long 4 kW electrical heaters are installed around the hole 1 m away. The experiment setup is described and results from predictive numerical modelling are shown. Elastoplastic modelling using the Ottosen failure criterion predicts damage initiation on week 5 and the concrete ultimate strain limit of 0.0035 is exceeded on week 10. The support pressure generated by the liner is 3.2 MPa and the tangential stress of rock is reduced by -33 %. In 2D fracture mechanical simulations, the support pressure is 3 MPa and small localized damage occurs after week 3 and damage process slowly continues during week 9 of the heating period. In conclusion, external heating is a potent way of inducing damage and thin concrete liner significantly reduces the amount of damage.
AlkuperäiskieliEnglanti
Artikkeli4723017
Sivumäärä17
JulkaisuJournal of Engineering
Vuosikerta2017
DOI - pysyväislinkit
TilaJulkaistu - 31 tammik. 2017
OKM-julkaisutyyppiA1 Alkuperäisartikkeli tieteellisessä aikakauslehdessä

Sormenjälki

Sukella tutkimusaiheisiin 'Elastoplastic Modelling of an In Situ Concrete Spalling Experiment using the Ottosen Failure Criterion'. Ne muodostavat yhdessä ainutlaatuisen sormenjäljen.

Siteeraa tätä