Effect of mechanical mismatch on fracture mechanical behavior of SA 508 – Alloy 52 narrow gap dissimilar metal weld

Tutkimustuotos: Lehtiartikkelivertaisarvioitu

Tutkijat

  • Teemu Sarikka
  • Matias Ahonen
  • Roman Mouginot
  • Pekka Nevasmaa
  • Päivi Karjalainen-Roikonen
  • Ulla Ehrnstén
  • Hannu Hänninen

Organisaatiot

  • VTT Technical Research Centre of Finland

Kuvaus

In modern pressurized water reactor (PWR) designs, dissimilar metal welds (DMW) between the reactor pressure vessel (RPV) nozzles and safe-ends connected to the main coolant pipes are manufactured using a narrow-gap welding (NGW) technique. In addition to the new weld design, the filler metals have been changed from conventional Alloys 82 and 182 to higher Cr containing Alloys 52 and 152 to ensure the structural integrity of the welds during long term operation. The changes in weld design and filler metal have an effect on the mechanical mismatch state of the DMW which has an effect on the fracture behavior of the weld. For the experimental determination of the local strength variations and the fracture mechanical behavior of a modern NG-DMW, a weld mock-up consisting of SA 508 pressure vessel steel with AISI 309L/308L cladding, AISI 304 piping steel, and Alloy 52 weld metal was manufactured. The NG-DMW was characterized in both as-welded and post-weld heat treated (PWHT) conditions. The results showed that the highest strength mismatch existed between the carbon-depleted zone (CDZ) in the SA 508 heat-affected zone (HAZ) and the Alloy 52 weld metal. High fracture toughness values were observed for the different zones of the weld and the crack propagation occurred towards the softer SA 508 HAZ CDZ.

Yksityiskohdat

AlkuperäiskieliEnglanti
Sivut30-42
Sivumäärä13
JulkaisuInternational Journal of Pressure Vessels and Piping
Vuosikerta157
TilaJulkaistu - 1 marraskuuta 2017
OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

ID: 15862022