Development of a dynamic model for a cone bolt

L. St-Pierre*, F. P. Hassani, P. H. Radziszewski, J. Ouellet

*Tämän työn vastaava kirjoittaja

Tutkimustuotos: LehtiartikkeliArticleScientificvertaisarvioitu

70 Sitaatiot (Scopus)

Abstrakti

To ensure safety in underground excavations, it is important that the support systems used are capable of resisting the dynamic loads produced, for example, by rock bursts. In this paper, a dynamic simulation model for a cone bolt is proposed based on an experimental study. Drop weight tests were performed on resin-based cone bolts. These experiments revealed that the bolt has two energy absorption mechanisms: sliding in the resin and plastic deformation. To simulate this behaviour, a two degrees-of-freedom lumped-mass model is proposed. Experimentally, the proportions of sliding and plastic deformation were found to vary significantly from one test to another. To account for this variability, two methods are proposed to determine the value of the parameters governing the sliding of the bolt in the resin, whereas a dynamic force-elongation model is used to simulate the plastic deformation. Comparing the results of a simulation to experimental data proved that the constitutive elements of the model are appropriate to simulate the dynamic response of the cone bolt.

AlkuperäiskieliEnglanti
Sivut107-114
Sivumäärä8
JulkaisuInternational Journal of Rock Mechanics and Mining Sciences
Vuosikerta46
Numero1
DOI - pysyväislinkit
TilaJulkaistu - tammik. 2009
OKM-julkaisutyyppiA1 Alkuperäisartikkeli tieteellisessä aikakauslehdessä

Sormenjälki

Sukella tutkimusaiheisiin 'Development of a dynamic model for a cone bolt'. Ne muodostavat yhdessä ainutlaatuisen sormenjäljen.

Siteeraa tätä