Agglomeration tendency of a fluidized bed during addition of different phosphate compounds

Christoffer Sevonius*, Patrik Yrjas, Daniel Lindberg, Leena Hupa

*Tämän työn vastaava kirjoittaja

Tutkimustuotos: LehtiartikkeliArticleScientificvertaisarvioitu

Abstrakti

Phosphorus has been observed to cause agglomeration during fluidized bed combustion of phosphorus-rich biomass. Phosphorus can react with alkali during combustion, forming low melting phosphates that glue the bed particles together, or form phosphates that react with the bed material. In this work, seven different phosphate compounds (KH2PO4, NaH2PO4, CaHPO4, NH4H2PO4, K3PO4, Na3PO4, Ca3(PO4)2) were tested. Experiments were performed in an electrically heated laboratory-scale fluidized bed reactor at 750, 800, 850 and 900 °C and the feeding of the phosphates continued until defluidization occurred or until 10 g of a phosphate-compound had been added. Defluidization was detected by a sudden decrease in the pressure drop over the bed and a simultaneous increase in the temperature difference between the upper and lower bed. Samples of the bed material were taken after each test and cast in epoxy, ground and polished to get a cross-section and then analyzed with SEM/EDX. KH2PO4, NaH2PO4, and NH4H2PO4 were found to cause defluidization by melt formation whereas K3PO4 and Na3PO4 caused defluidization via reaction with the quartz bed material forming alkali silicate.

AlkuperäiskieliEnglanti
Artikkeli117300
JulkaisuFuel
Vuosikerta268
DOI - pysyväislinkit
TilaJulkaistu - 15 toukokuuta 2020
OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

Sormenjälki Sukella tutkimusaiheisiin 'Agglomeration tendency of a fluidized bed during addition of different phosphate compounds'. Ne muodostavat yhdessä ainutlaatuisen sormenjäljen.

  • Siteeraa tätä