Additively manufactured high-performance counterflow heat exchanger

Tutkimustuotos: Lehtiartikkelivertaisarvioitu

Tutkijat

Organisaatiot

Kuvaus

The purpose of this article is to demonstrate that additive manufacturing is a viable method for producing counterflow heat exchangers that have a very high power to volume ratio. For this study, a heat exchanger with 144 flow channels in a checkerboard pattern was designed and additively manufactured from AlSi10Mg. The heat exchanger was tested by measuring the heat transfer between two liquids in a counterflow set-up, where it reached exceptionally high performance when considering its volume and weight. The heat transfer properties of the heat exchanger were verified analytically through calculations, which identified that the high surface roughness of the channels provides a significant improvement in heat transfer properties. The heat transfer capabilities were measured on two separate occasions to investigate the possible change of properties of additively manufactured heat exchangers over time when used with tap water. A moderate decrease in heat flow and increase in pressure drop were noted between the measurements. The deterioration of heat transfer capabilities could present a significant challenge for additively manufactured heat transfer applications and will be closely examined in future research.

Yksityiskohdat

AlkuperäiskieliEnglanti
Sivut55-61
Sivumäärä7
JulkaisuProgress in Additive Manufacturing
Vuosikerta4
Numero1
Varhainen verkossa julkaisun päivämäärä26 heinäkuuta 2018
TilaJulkaistu - 1 maaliskuuta 2019
OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

Lataa tilasto

Ei tietoja saatavilla

ID: 27113772