Validation of SOLPS-ITER and EDGE2D-EIRENE simulations for H, D, and T JET ITER-like wall low-confinement mode plasmas

N. Horsten*, M. Groth, V. P. Rikala, B. Lomanowski, A. G. Meigs, S. Aleiferis, X. Bonnin, G. Corrigan, W. Dekeyser, R. Futtersack, D. Harting, D. Reiter, V. Solokha, B. Thomas, S. Van den Kerkhof, N. Vervloesem, JET Contributors

*Corresponding author for this work

Research output: Contribution to journalArticleScientificpeer-review

1 Citation (Scopus)
13 Downloads (Pure)

Abstract

Both experiments and simulations with SOLPS-ITER and EDGE2D-EIRENE show that the onset of detachment for the low-field side (LFS) divertor – defined here as the line-averaged upstream density (〈needge) at which the plasma flux to the LFS target (ILFS−plate) starts to decrease with increasing 〈needge – is independent of the isotope mass. However, there are three major simulation-experiment discrepancies: (i) the absolute values of ILFS−plate and the electron density (ne) in the LFS divertor at the onset of detachment are significantly lower in simulations, i.e., approximately a factor of 2 for ILFS−plate and a factor of 3-4 for ne; (ii) the degree of detachment – defined here as the difference between ILFS−plate at the onset of detachment and at an 〈needge value close to the density limit – is smaller in simulations compared to experiments; and (iii) the experimentally observed larger degree of detachment for D and T plasmas compared to H plasmas cannot be clearly distinguished from the simulation results. There are strong indications that discrepancy (i) is to a large extent caused by neglecting Lyman-opacity effects in our simulations. The simulations predict a similar net volumetric recombination source for all isotopes due to the fact that molecule-activated recombination (MAR) compensates for the reduced electron–ion recombination (EIR) for H, whereas MAR is negligible for D and T. This similar net volumetric recombination source for all isotopes leads to an isotope-independent degree of detachment in simulations. An analysis of the Balmer-α and Balmer-γ emission confirms the underestimate of MAR in simulations (especially for D and T) for the JET metallic wall, which was previously observed for devices with a carbon wall. The underestimate of MAR is an important cause for discrepancy (ii) and the fact that there is a stronger underestimate of MAR for D and T than for H explains discrepancy (iii). Extending the plasma grid to the vessel wall increases ILFS−plate and ne at the onset of detachment by 25%, and the EIR source increases by 80% in detached conditions. Hence, while the extended grid results are closer to the experimental observations, the previously described qualitative discrepancies still persist.

Original languageEnglish
Article number101842
Pages (from-to)1-12
Number of pages12
JournalNuclear Materials and Energy
Volume42
Early online date15 Dec 2024
DOIs
Publication statusPublished - Mar 2025
MoE publication typeA1 Journal article-refereed

Keywords

  • Balmer emission
  • Divertor detachment
  • Lyman opacity
  • Plasma edge code validation

Fingerprint

Dive into the research topics of 'Validation of SOLPS-ITER and EDGE2D-EIRENE simulations for H, D, and T JET ITER-like wall low-confinement mode plasmas'. Together they form a unique fingerprint.

Cite this