Using online bubble size and total dissolved solids measurements to investigate the performance of oxygen delignification

Research output: Contribution to journalArticleScientificpeer-review

Researchers

Research units

  • Andritz Oy
  • South Eastern Finland University of Applied Sciences

Abstract

The main target of oxygen delignification is to continue delignification that started in cooking in a more selective manner than occurs in the digester (i.e., remove a substantial fraction of the residual lignin using oxygen and alkali at a moderate temperature). Delignification with oxygen is a gentler way of reducing the kappa number than extended cooking. Lowering inlet kappa to bleaching also decreases bleaching chemicals consumption and, because of this, reduces organic wastewater load from bleaching.

We studied the performance of oxygen delignification by installing bubble size imaging systems and refractometers, which measure dissolved dry solids in the oxygen stage feed. Based on these measurements, we gathered information about gas dispersion (bubble size distribution) and the behavior of dissolved matter in the hardwood mill's oxygen delignification stage. Our goal was to investigate the effects of different variables on the oxygen stage's gas dispersion, kappa reduction, yield, and pulp quality. Gas dispersion improved (i.e., average bubble size decreased) when the chemical mixer speed increased. Increasing the mixer speed and the amount of oxygen yielded higher kappa number reductions and increased the amount of dissolved organic matter.

Details

Original languageEnglish
Pages (from-to)343-350
Number of pages8
JournalTAPPI Journal
Volume17
Issue number6
Publication statusPublished - Jun 2018
MoE publication typeA1 Journal article-refereed

Download statistics

No data available

ID: 27284235