Time constants for temperature elevation in human models exposed to dipole antennas and beams in the frequency range from 1 to 30 GHz

Research output: Contribution to journalArticleScientificpeer-review

Researchers

  • Ryota Morimoto
  • Akimasa Hirata
  • Ilkka Laakso

  • Marvin C. Ziskin
  • Kenneth R. Foster

Research units

  • Nagoya Institute of Technology
  • Temple University
  • University of Pennsylvania

Abstract

This study computes the time constants of the temperature elevations in human head and body models exposed to simulated radiation from dipole antennas, electromagnetic beams, and plane waves. The frequency range considered is from 1 to 30 GHz. The specific absorption rate distributions in the human models are first computed using the finite-difference time-domain method for the electromagnetics. The temperature elevation is then calculated by solving the bioheat transfer equation. The computational results show that the thermal time constants (defined as the time required to reach 63% of the steady state temperature elevation) decrease with the elevation in radiation frequency. For frequencies higher than 4 GHz, the computed thermal time constants are smaller than the averaging time prescribed in the ICNIRP guidelines, but larger than the averaging time in the IEEE standard. Significant differences between the different head models are observed at frequencies higher than 10 GHz, which is attributable to the heat diffusion from the power absorbed in the pinna. The time constants for beam exposures become large with the increase in beam diameter. The thermal time constant in the brain is larger than that in the superficial tissues at high frequencies, because the brain temperature elevation is caused by the heat conduction of energy absorbed in the superficial tissue. The thermal time constant is minimized with an ideal beam with a minimum investigated diameter of 10 mm; this minimal time constant is approximately 30 s and is almost independent of the radiation frequency, which is supported by analytic methods. In addition, the relation between the time constant, as defined in this paper, and 'averaging time' as it appears in the exposure limits is discussed, especially for short intense pulses. Similar to the laser guidelines, provisions should be included in the limits to limit the fluence for such pulses.

Details

Original languageEnglish
Pages (from-to)1676-1699
Number of pages24
JournalPhysics in Medicine and Biology
Volume62
Issue number5
Publication statusPublished - 6 Feb 2017
MoE publication typeA1 Journal article-refereed

    Research areas

  • international guidelines for human safety, new frequency bands, radio-frequency dosimetry, radio-frequency-induced temperature elevation

ID: 11151021