Surface Integrity Analysis of Abrasive Water Jet-Cut Surfaces of Friction Stir Welded Joints

Research output: Contribution to journalArticleScientificpeer-review

Researchers

Research units

  • Indian Institute of Technology, Dhanbad
  • Institute of Geonics of the CAS
  • Faculty of Manufacturing Technologies TUKE

Abstract

Nowadays, the abrasive water jet (AWJ) technology is much in use for cutting materials into complex shapes with high dimensional accuracy. The objective of the present paper is to study the topography as well as the roughness of the surfaces in friction stir welded (FSW) joints, machined by AWJ. It discusses machinability of the FSW joints by AWJ. Subsequently, this paper makes a critical analysis of the surface
properties by optical profilometer. Top and bottom surfaces, created by FSW, have also been analyzed using an optical 3D measurement system to determine the morphology and topographic parameters. FSW possesses favourable joining properties and generates a minimum heat-affected zone (HAZ) because of its comparatively low temperature coalescence. Three friction stir welding samples were prepared at
500, 710 and 1000 rpm with a welding speed of 40 mm/min on AA 6101-T6. After analysis, it was found that the sample prepared at 500 rpm and with welding speed of 40 mm/min produces a surface fit for industrial applications in terms of surface roughness and dimensional accuracy. It has also been observed that unlike other conventional or non-conventional processes, no HAZ is generated during the cutting of FSW joints by using the AWJ technology.

Details

Original languageEnglish
Pages (from-to)1687-1701
JournalInternational Journal of Advanced Manufacturing Technology
Volume88
Issue number5-8
Publication statusPublished - 2017
MoE publication typeA1 Journal article-refereed

Download statistics

No data available

ID: 10404798