Components selection of a direct three-phase to single-phase AC/AC converter for a contactless electric vehicle charger

Ferdi Perdana Kusumah; Simo Vuorsalo; Jorma Kyyrä

doi:10.1109/EPE.2016.7695411

Components selection of a direct three-phase to single-phase AC/AC converter for a contactless electric vehicle charger

Ferdi Perdana Kusumah, Simo Vuorsalo, Jorma Kyyrä

Research output: Chapter in Book/Report/Conference proceeding › Conference article in proceedings › Scientific › peer-review

9 Citations (Scopus)

101 Downloads (Pure)

Abstract

This paper explains a procedure on how to select resonant circuit components of a unique direct three-phase to single-phase AC/AC converter for a contactless electric vehicle (EV) charger. The topology has a fewer bi-directional switches than a matrix converter and consists of a resonant circuit to utilize a zero-current switching (ZCS) mechanism. The selection goal was to realize a working prototype that does not violate each electrical component's limitations as well as has a low resonant damping ratio since the switches are driven based on a resonant current. Selection methods were based on graphical analysis of damping factor, resonant frequency, and primary circuit voltage and current characteristics derived from dynamic and steady-state models. Simulation results are then presented to validate the selection procedures.

Original language	English
Title of host publication	Proceedings of the 2016 18th European Conference on Power Electronics and Applications, EPE 2016 ECCE Europe
Publisher	IEEE
ISBN (Electronic)	9789075815245
DOIs	https://doi.org/10.1109/EPE.2016.7695411
Publication status	Published - 25 Oct 2016
MoE publication type	A4 Conference publication
Event	European Conference on Power Electronics and Applications - Convention Centre Karlsruhe, Karlsruhe, Germany Duration: 5 Sept 2016 → 9 Sept 2016 Conference number: 18 http://www.epe2016.com

Publication series

Name	European Conference on Power Electronics and Applications
Publisher	Institute of Electrical and Electronics Engineers Inc.
ISSN (Print)	2325-0313

Conference

Conference	European Conference on Power Electronics and Applications
Abbreviated title	EPE'16 ECCE
Country/Territory	Germany
City	Karlsruhe
Period	05/09/2016 → 09/09/2016
Internet address	http://www.epe2016.com

Keywords

AC/AC converter
Battery charger
Contactless power supply
Electric vehicle
Resonant converter
Soft switching

Access to Document

10.1109/EPE.2016.7695411

ELEC_Kusumah_etal_Components-Selection_EPE_ECCE_2016_acceptedauthormanuscriptAccepted author manuscript, 2.53 MB

Cite this

Kusumah, F. P., Vuorsalo, S., & Kyyrä, J. (2016). Components selection of a direct three-phase to single-phase AC/AC converter for a contactless electric vehicle charger. In Proceedings of the 2016 18th European Conference on Power Electronics and Applications, EPE 2016 ECCE Europe Article 7695411 (European Conference on Power Electronics and Applications). IEEE. https://doi.org/10.1109/EPE.2016.7695411

@inproceedings{0ca77f61b448416e9690ec560cfdc5de,

title = "Components selection of a direct three-phase to single-phase AC/AC converter for a contactless electric vehicle charger",

abstract = "This paper explains a procedure on how to select resonant circuit components of a unique direct three-phase to single-phase AC/AC converter for a contactless electric vehicle (EV) charger. The topology has a fewer bi-directional switches than a matrix converter and consists of a resonant circuit to utilize a zero-current switching (ZCS) mechanism. The selection goal was to realize a working prototype that does not violate each electrical component's limitations as well as has a low resonant damping ratio since the switches are driven based on a resonant current. Selection methods were based on graphical analysis of damping factor, resonant frequency, and primary circuit voltage and current characteristics derived from dynamic and steady-state models. Simulation results are then presented to validate the selection procedures.",

keywords = "AC/AC converter, Battery charger, Contactless power supply, Electric vehicle, Resonant converter, Soft switching",

author = "Kusumah, {Ferdi Perdana} and Simo Vuorsalo and Jorma Kyyr{\"a}",

year = "2016",

month = oct,

day = "25",

doi = "10.1109/EPE.2016.7695411",

language = "English",

series = "European Conference on Power Electronics and Applications",

publisher = "IEEE",

booktitle = "Proceedings of the 2016 18th European Conference on Power Electronics and Applications, EPE 2016 ECCE Europe",

address = "United States",

note = "European Conference on Power Electronics and Applications, EPE'16 ECCE ; Conference date: 05-09-2016 Through 09-09-2016",

url = "http://www.epe2016.com",

}

Kusumah, FP, Vuorsalo, S & Kyyrä, J 2016, Components selection of a direct three-phase to single-phase AC/AC converter for a contactless electric vehicle charger. in Proceedings of the 2016 18th European Conference on Power Electronics and Applications, EPE 2016 ECCE Europe., 7695411, European Conference on Power Electronics and Applications, IEEE, European Conference on Power Electronics and Applications, Karlsruhe, Germany, 05/09/2016. https://doi.org/10.1109/EPE.2016.7695411

Components selection of a direct three-phase to single-phase AC/AC converter for a contactless electric vehicle charger. / Kusumah, Ferdi Perdana; Vuorsalo, Simo; Kyyrä, Jorma.
Proceedings of the 2016 18th European Conference on Power Electronics and Applications, EPE 2016 ECCE Europe. IEEE, 2016. 7695411 (European Conference on Power Electronics and Applications).

Research output: Chapter in Book/Report/Conference proceeding › Conference article in proceedings › Scientific › peer-review

TY - GEN

T1 - Components selection of a direct three-phase to single-phase AC/AC converter for a contactless electric vehicle charger

AU - Kusumah, Ferdi Perdana

AU - Vuorsalo, Simo

AU - Kyyrä, Jorma

N1 - Conference code: 18

PY - 2016/10/25

Y1 - 2016/10/25

N2 - This paper explains a procedure on how to select resonant circuit components of a unique direct three-phase to single-phase AC/AC converter for a contactless electric vehicle (EV) charger. The topology has a fewer bi-directional switches than a matrix converter and consists of a resonant circuit to utilize a zero-current switching (ZCS) mechanism. The selection goal was to realize a working prototype that does not violate each electrical component's limitations as well as has a low resonant damping ratio since the switches are driven based on a resonant current. Selection methods were based on graphical analysis of damping factor, resonant frequency, and primary circuit voltage and current characteristics derived from dynamic and steady-state models. Simulation results are then presented to validate the selection procedures.

AB - This paper explains a procedure on how to select resonant circuit components of a unique direct three-phase to single-phase AC/AC converter for a contactless electric vehicle (EV) charger. The topology has a fewer bi-directional switches than a matrix converter and consists of a resonant circuit to utilize a zero-current switching (ZCS) mechanism. The selection goal was to realize a working prototype that does not violate each electrical component's limitations as well as has a low resonant damping ratio since the switches are driven based on a resonant current. Selection methods were based on graphical analysis of damping factor, resonant frequency, and primary circuit voltage and current characteristics derived from dynamic and steady-state models. Simulation results are then presented to validate the selection procedures.

KW - AC/AC converter

KW - Battery charger

KW - Contactless power supply

KW - Electric vehicle

KW - Resonant converter

KW - Soft switching

UR - http://www.scopus.com/inward/record.url?scp=84996636556&partnerID=8YFLogxK

U2 - 10.1109/EPE.2016.7695411

DO - 10.1109/EPE.2016.7695411

M3 - Conference article in proceedings

AN - SCOPUS:84996636556

T3 - European Conference on Power Electronics and Applications

BT - Proceedings of the 2016 18th European Conference on Power Electronics and Applications, EPE 2016 ECCE Europe

PB - IEEE

T2 - European Conference on Power Electronics and Applications

Y2 - 5 September 2016 through 9 September 2016

ER -

Kusumah FP, Vuorsalo S, Kyyrä J. Components selection of a direct three-phase to single-phase AC/AC converter for a contactless electric vehicle charger. In Proceedings of the 2016 18th European Conference on Power Electronics and Applications, EPE 2016 ECCE Europe. IEEE. 2016. 7695411. (European Conference on Power Electronics and Applications). doi: 10.1109/EPE.2016.7695411

Components selection of a direct three-phase to single-phase AC/AC converter for a contactless electric vehicle charger

Abstract

Publication series

Conference

Keywords

Access to Document

Other files and links

Fingerprint

A direct three-phase to single-phase AC/AC converter for contactless electric vehicle charger

Cite this