Atomic layer deposited aluminium oxide mitigates outgassing from fused filament fabrication–based 3-D printed components

Ismo T.S. Heikkinen, Giovanni Marin, Nupur Bihari, Craig Ekstrum, Pierce J. Mayville, Yuhuan Fei, Yun Hang Hu, Maarit Karppinen, Hele Savin, Joshua M. Pearce

Research output: Contribution to journalArticleScientificpeer-review

Abstract

Open-source scientific hardware based on affordable fused filament fabrication (FFF) 3-D printing has the potential to reduce the cost of research tools considerably. So far, development has focused on tools that do not require compatibility with vacuum environments. Highly porous 3-D printed plastics require surface treatments to mitigate their outgassing, and in this study we explored the outgassing reduction from 3-D printed black-colored acrylonitrile butadiene styrene (ABS) and polycarbonate (PC) using a commercial vacuum sealing resin as well as atomic layer deposited (ALD) aluminium oxide (AlOx). The outgassing properties of uncoated plastics could not be measured due to a too high level of outgassing, which was attributed to their high porosity and high specific surface area. However, both the commercial resin and the ALD coatings reduced the extent of outgassing from both ABS and PC, which enabled their comparison by residual gas analysis (RGA). Remarkably, the outgassing performance achieved with ALD AlOx was superior to the performance of the commercial vacuum resin across a temperature range of 40 to 100 °C for both plastics, despite the uneven coverage of the plastic surface with AlOx. Results indicated that both ABS and PC could be made compatible with at least moderate vacuums using ALD AlOx. Thus, the fabrication of laboratory vacuum tools can be realized with affordable 3-D printed plastics. However, further studies on the physical mechanisms behind the outgassing reduction and the durability of the coatings are required.
Original languageEnglish
Article number125459
Number of pages24
JournalSurface and Coatings Technology
Volume386
Early online dateFeb 2020
DOIs
Publication statusPublished - Feb 2020
MoE publication typeA1 Journal article-refereed

Keywords

  • Atomic layer deposition
  • Aluminium oxide
  • Outgassing
  • Vacuum compatibility
  • 3-D printed plastics

Fingerprint Dive into the research topics of 'Atomic layer deposited aluminium oxide mitigates outgassing from fused filament fabrication–based 3-D printed components'. Together they form a unique fingerprint.

  • Projects

    CloseLoop: Closing the Loop for High-added-value Materials

    Kauranen, P., Blomberg, T., Heiska, J., Karppinen, M. & Kousar, S.

    01/04/201615/01/2020

    Project: Academy of Finland: Strategic research funding

    Equipment

    OtaNano

    Anna Rissanen (Manager)

    Aalto University

    Facility/equipment: Facility

  • Cite this